Edelbrock | Fuel Injection System

Edelbrock - Fuel Injection System

 

Description

The Edelbrock Pro-Flo 4 XT EFI Kit #35813 for 1986-earlier Small-Block Chevrolet engines is a complete bolt-on electronic fuel injection system featuring a black powder-coated XT intake manifold with large plenum and long tapered runners that comes ready to run with high-flow injectors, fuel rails and 90mm throttle body preassembled for you at the Edelbrock factory. This kit is rated at a maximum 625 horsepower with 35 lb/hr injectors and includes all supporting sensors, a wide-band O2 sensor, wire harnesses and Android-based tablet. Also included is a single-connection distributor designed to work specifically with Pro-Flo 4 providing fully sequential port injection and infinite control over ignition and fuel events under all conditions. Key Pro-Flo 4 advancements are its Self-Calibrating Fuel Map Technology, Wide-Band O2 Closed Loop Mixture Control, and new low-profile ECU with faster processor and upgraded Bluetooth chip for reliable connectivity with the E-Tuner app that comes preinstalled on the tablet. The E-Tuner includes a Setup Wizard to guide you through setup and provides fuel and spark adjustability for complete control over the system. Pro-Flo 4 EFI #35813 for the Small-Block Chevy requires no laptop tuning. Minimal setup and tuning adjustments are required with base calibrations provided in the software. The ECU is self-learning and will continually adjust the fuel injection calibration for maximum performance by maintaining a specified target air-fuel ratio as you drive. The E-Tuner provides the ability to fine-tune air-fuel ratios, ignition curve, idle speed, acceleration fuel, fans, rev-limiter and more. Multiple displays let you monitor engine performance in real-time from inside or outside of the vehicle while retaining the simplicity that Pro-Flo 4 systems are known for.

 

Caracteristics

• Fuel Pressure Port: 1/8-27 NPT
• Finish: Black
• Gasket Or Seal Included: Yes
• Wiring Harness Included: Yes
• Quantity: Kit
• Bore Diameter: 90
• Throttle Body Type: Single Blade
• Fuel Injector Type: 35 lb/hr
• System Type: XT-Style Kit
• Manifold Height: A-9.2 in, B-8.4 in, C-16.9 in, D-2.1 in, E-0 Degrees
• Maximum Horsepower: 550
• Flange Type: XT-Style
• Wire Harness Included: Yes
• Distributor Cap Included: Yes

 

Note:

• Livraison GRATUITE / FREE Delivery