BBK Performance | Headers - Long Tube Céramique 1-3/4" - Mustang 1986-2004

Description:

• Put a Coyote 5.0 in Your Earlier Model Mustang
• 20+ Horsepower Increase Over Factory Header
• Large 1-3/4" Primaries
• 3/8" Thick Flanges and 16 Gauge Steel Tubing
• For Use With BBK Short Mid Pipes
• Gaskets and Hardware Included
• Fits with Manual Transmission and Aftermarket K-Member Only
• Durable ceramic coated finish

Put a Coyote 5.0 in Your Mustang!

These BBK Coyote swap headers are constructed from mandrel bent high flow 1-3/4" tubing with 3" collectors making them perfect for both naturally aspirated and supercharged builds. These full length headers will help give your Coyote powered Mustang a throaty exhaust note. The ceramic coated finish adds a touch of style to your engine bay.

Quality Construction:

BBK Coyote swap full length Mustang headers are made from 1-3/4" CNC mandrel bent tubing with 3/8" thick die-stamped flanges. The full length primary tube design creates unrestricted and balanced airflow for ultimate horsepower gains. These headers are pressure tested to ensure leak free performance.

Installation:

These Headers were designed using a Maximum Motorsports K member and manual transmission. May not clear with other combinations. For use with BBK Performance short mid pipes.

Fits:

1979-2004 Mustang Chassis with 2011+ 5.0L Coyote Engine Swap
Designed using a Maximum Motorsports K-member and manual transmission. May not fit other configurations without modification. 3" Matching Short X pipes with or with out converters are also available to connect up to the Cat back Exhaust (Minor Exhaust Fabrication Required) Because they are 3 inch you will need a new 3" Cat-back exhaust system or modify the stock Cat-back to fit. We highly recommend New 3" system. 87-93 Mustang GT only 3" Cat Back Flowmaster Part# 17396 was used with required modifications

Please Note:

These BBK Long Tube Headers require the use of Front O2 wire harness extensions - these are not included and are recommended for installation Please check the GEN Coyote engine that you have and order the correct harness - GEN1 Coyote 11-14 requires Part # 1112 - GEN2 Coyote 15-17 requires Part # 1119 - GEN3 Coyote 18-19 requires Part # 1121

Please Note: Designed to work on Manual Transmissions ONLY