AEM | WATER / METHANOL INJECTION KIT V3 - 5 GALLON

AEM V3 HD Boost Water/Methanol Injection Kit – 5 Gallon

Part Number: 30-3301 (Boost 0–35 PSI)

The AEM Water/Methanol Injection System Advantage

Water/methanol injection for forced induction (turbocharged or supercharged) gas-powered race engines is a proven means for effectively reducing engine inlet air temperatures and suppressing harmful detonation. This allows racers to reliably increase boost and advance ignition timing — without using high-octane racing fuel — for power gains of up to 20%. AEM’s Water/Methanol Injection Systems utilize the most robust hardware combined with more advanced features than any other comparably priced water/methanol system.

AEM offers a boost-dependent water/methanol controller for gas vehicles: designed for forced induction vehicles up to 35 PSI of boost (kit PN 30-3301). The Boost Dependent controller has an on-board MAP sensor with a molded-in nipple for a boost hose pickup.

Note: For optimum results, all water/methanol injection systems should be run with an AEM Inline Filter (AEM Part #30-3003).

This product may be used solely on vehicles used in sanctioned competition which may never be used upon a public road or highway, unless permitted by specific regulatory exemption. It is the responsibility of the installer and/or user to ensure compliance with all applicable laws and regulations.

Important Safety Notice Regarding Methanol

AEM strongly recommends never exceeding a 50% methanol concentration. All AEM Water/Methanol injection systems and components are 100% chemically compatible with methanol. However, for safety reasons, never use more than a 50% methanol concentration. Methanol is toxic and highly flammable — improper use can cause blindness or death.

WARNING: Improper installation and/or adjustment of this product can result in major engine/vehicle damage. AEM holds no responsibility for engine damage or personal injury resulting from misuse of this product.

Note:

• Livraison GRATUITE / FREE Delivery