JLT Performance | BIG Air Intake - Mustang GT500 2007-2009

JLT Performance - BIG Air Intake

BIG AIR INTAKE TUBE WITH MOLDED IN MAF
The best part of our Big Air intake is we kicked the cool factor up a notch and molded a 123mm MAF housing right in the tube. With no separate MAF housing or couplers air flow is fast and smooth.. Early testing shows this can be used with the stock MAF sensor all the way up to 750 RWHP and well beyond with a MAFia, SCT BA5000 or HPX sensor.

HEAT SHIELD
Includes our new roto molded heat shield to block engine heat at idle and low speed. It has two mounting points and a weather strip that seals to the hood and uses a large area to make sure the filter has tons of cool air.

GAINS
60-90 RWHP is typical with this kit and our custom tune. This puts most GT500’s at 495-515 HP at the rear tires. (500 HP is rated at the flywheel from the factory)

TUNING
A JLT specific tune is required with this kit.

FINISH OPTIONS
Standard finish is an OEM looking black textured plastic.

EASY INSTALL
The new design, detailed instructions and online video instructions helps make this an easy install (see Instructions & Videos tabs to download / view).

KIT INCLUDES:

• JLT Intake Tube with Black Textured finish
• Silicone Coupler
• 5x7 S&B Powerstack Air Filter
• Roto Molded Heat Shield
• HD Clamps & all needed hardware

AIR FILTER: OIL OR DRY
We use only the best air filters made by S&B to our specifications.
For years we only used oiled filters, but dry filter technology has been proven and is now a popular option.

Should I choose a Dry Disposable or Cotton Oiled Filter?
Since you are not sacrificing performance with either choice, the decision comes down to would you rather throw away the filter or clean it.

Dry:
Comparable Airflow to oiled Cotton Filters with the same Great Protection. Last for up to 30,000 miles of highway driving. Extend the life of the filter using compressed air.

OIL:
Oiled filters can last forever as long as you properly clean and re-oil it. See maintenance information below.

JLT Pre-Filters are now available for most intake kits we carry, these filters are made for us by Outerwears, these prefilters are water repellent. They will increase your filter life and cut down on your cleaning intervals!

MAINTENANCE
To properly clean your filter, we recommend the S&B Precision II Cleaning & Oiling Kit.
*TIP* by purchasing a 2nd air filter you can simply swap filters when it's time to clean it and not be rushed. Clean the first filter and it's ready when it's time to change again.

Custom tuning is required

Note:

• Livraison GRATUITE / FREE Delivery